IEEE

Capacitors

SHARE |

From GHN

(Difference between revisions)
Jump to: navigation, search
(added units)
(16 intermediate revisions by 3 users not shown)
Line 1: Line 1:
 
== Capacitors  ==
 
== Capacitors  ==
  
[[Image:Capacitors.jpg|thumb|left|These are examples of modern capacitors. They measure about an inch long and might be found in radios or televisions. Capacitors come in all sizes, from car-size ones that are used in electric power distribution to microscopic ones built into integrated circuits.]] A capacitor is a device for temporarily storing electric charge. What is considered to be the very first capacitor was called the Leyden jar, which was invented by Pieter van Musschenbroek in 1746 at the University of Leyden (or Leiden) in Holland. It was a glass jar wrapped inside and out by a thin metal foil. The outer foil was connected to the ground, and the inner foil was connected to a source of electricity such as an electrostatic generator. Although how it works was not understood at the time, experimenters discovered that the Leyden jar seemed to store an electric charge even after it was disconnected from the generator. Like many early electrical devices, there was no particular use for the Leyden jar at first, other than to allow scientists to do a greater variety of electrical experiments. Benjamin Franklin, for example, used a Leyden jar to store electricity from lightning in his famous kite flying experiment in 1752. By doing so he proved that lightning was really electricity.
+
<p>[[Image:Capacitors.jpg|thumb|left|These are examples of modern capacitors. They measure about an inch long and might be found in radios or televisions. Capacitors come in all sizes, from car-size ones that are used in electric power distribution to microscopic ones built into integrated circuits.]] </p>
  
Capacitors such as a Leyden jar consist of layers made of an electrically conducting material (such as metal foil) separated by layers of a nonconducting material (glass in the case of the Leyden jar, but it can also be wax, mica, oil, paper, tantalum, plastic, ceramic material, or even air). If an electrical voltage is applied to the layers of a capacitor, the plates will become charged, one positively and one negatively. If the externally applied voltage is then removed, the plates of the capacitor remain charged, and the presence of the electric charge induces an electrical potential between the plates. Today’s capacitors are used for a wide variety of purposes in electric power systems, radio receivers, computers, and nearly every other electrical device. They range in size from the size of a refrigerator to the microscopic capacitors built into integrated circuits. The capacity of the device for storing electric charge (called its capacitance) can be changed by changing the area of the plates, by increasing or decreasing their separation, or by using different kinds of materials for the non-conducting layers.<br>
+
<p>A capacitor is a device for temporarily storing electric charge. What is considered to be the very first capacitor was called the [[Leyden jar|Leyden jar]], which was invented by Pieter van Musschenbroek in 1746 at the University of Leyden (or Leiden) in Holland. It was a glass jar wrapped inside and out by a thin metal foil. The outer foil was connected to the ground, and the inner foil was connected to a source of electricity such as an electrostatic generator. Although how it works was not understood at the time, experimenters discovered that the Leyden jar seemed to store an electric charge even after it was disconnected from the generator. Like many early electrical devices, there was no particular use for the Leyden jar at first, other than to allow scientists to do a greater variety of electrical experiments. Benjamin Franklin, for example, used a Leyden jar to store electricity from lightning in his [[Kite Experiment|famous kite flying experiment]] in 1752. By doing so he proved that lightning was really electricity. </p>
  
== UNITS ==
+
<p>[[Image:3371-leyden jar.jpg|thumb|right|Leyden Jar]] </p>
  
The unit of capacitance was known as the "Jar" until 1888, and later the SI unit of "Coulomb" was assigned in 1922.
+
<p>Capacitors such as a Leyden jar consist of layers made of an electrically conducting material (such as metal foil) separated by layers of a nonconducting material (glass in the case of the Leyden jar, but it can also be wax, mica, oil, paper, tantalum, plastic, ceramic material, or even air). If an electrical voltage is applied to the layers of a capacitor, the plates will become charged, one positively and one negatively. If the externally applied voltage is then removed, the plates of the capacitor remain charged, and the presence of the electric charge induces an electrical potential between the plates. Today’s capacitors are used for a wide variety of purposes in electric power systems, radio receivers, computers, and nearly every other electrical device. They range in size from the size of a [[Refrigerator|refrigerator]] to the microscopic capacitors built into [[Integrated Circuits|integrated circuits]]. The capacity of the device for storing electric charge (called its capacitance) can be changed by changing the area of the plates, by increasing or decreasing their separation, or by using different kinds of materials for the non-conducting layers.<br></p>
  
[[Category:Components,_circuits,_devices_&_systems|Category:Components,_circuits,_devices_&amp;_systems]] [[Category:Electronic_components]] [[Category:Capacitors]]
+
<p>Capacitors are often given names to suit their applications eg: </p>
 +
 
 +
<p>- Bypass capacitors, to short circuit AC current </p>
 +
 
 +
<p>- Condenser, the name used for capacitors in circuits up to the 1950's. </p>
 +
 
 +
<p>- Tuning capacitors, to vary the frequency of a tuned circuit </p>
 +
 
 +
<p>- Power Factor Correction, used to reduce reactive currents in power distrubution networks </p>
 +
 
 +
<p>- Whimhurst Machine, to generate high voltage by maitaing a constant charge, but moving the capacitor plates farther apart (a square law relationship) </p>
 +
 
 +
<p>- Radio antennas, can exhibit capacitance at certain frequencies. </p>
 +
 
 +
== Inventors  ==
 +
 
 +
<p>In 1745 the Leyden jar was competitively invented by Ewald Jurgen von Kleist - 4 Nov 1745. Pieter van Musschenbroek produced the first working example in Jan 1746, with the name coming from Leiden University. In 1747 William Watson discharges a Leyden jar through a circuit and comprehends electric current.<br></p>
 +
 
 +
== Units of Measurement  ==
 +
 
 +
<p>The unit of capacitance was known as the "Jar" until 1872, when the SI unit of "Farad" was assigned. (Other units were assigned at this time, volt, ampere, coulomb, ohm and farad.)&nbsp;&nbsp; The term capacitor only became popular around the 1950's, and prior to that it was known as a condensor. </p>
 +
 
 +
<p>All practical realisations of the capacitor have some resistance, both leakage as well as charging&nbsp;and it is this combination which defines the 'loss factor'. </p>
 +
 
 +
[[Category:Components,_circuits,_devices_&_systems]]
 +
[[Category:Electronic_components]]
 +
[[Category:Capacitors]]

Revision as of 14:32, 10 January 2012

Capacitors

These are examples of modern capacitors. They measure about an inch long and might be found in radios or televisions. Capacitors come in all sizes, from car-size ones that are used in electric power distribution to microscopic ones built into integrated circuits.
These are examples of modern capacitors. They measure about an inch long and might be found in radios or televisions. Capacitors come in all sizes, from car-size ones that are used in electric power distribution to microscopic ones built into integrated circuits.

A capacitor is a device for temporarily storing electric charge. What is considered to be the very first capacitor was called the Leyden jar, which was invented by Pieter van Musschenbroek in 1746 at the University of Leyden (or Leiden) in Holland. It was a glass jar wrapped inside and out by a thin metal foil. The outer foil was connected to the ground, and the inner foil was connected to a source of electricity such as an electrostatic generator. Although how it works was not understood at the time, experimenters discovered that the Leyden jar seemed to store an electric charge even after it was disconnected from the generator. Like many early electrical devices, there was no particular use for the Leyden jar at first, other than to allow scientists to do a greater variety of electrical experiments. Benjamin Franklin, for example, used a Leyden jar to store electricity from lightning in his famous kite flying experiment in 1752. By doing so he proved that lightning was really electricity.

Leyden Jar
Leyden Jar

Capacitors such as a Leyden jar consist of layers made of an electrically conducting material (such as metal foil) separated by layers of a nonconducting material (glass in the case of the Leyden jar, but it can also be wax, mica, oil, paper, tantalum, plastic, ceramic material, or even air). If an electrical voltage is applied to the layers of a capacitor, the plates will become charged, one positively and one negatively. If the externally applied voltage is then removed, the plates of the capacitor remain charged, and the presence of the electric charge induces an electrical potential between the plates. Today’s capacitors are used for a wide variety of purposes in electric power systems, radio receivers, computers, and nearly every other electrical device. They range in size from the size of a refrigerator to the microscopic capacitors built into integrated circuits. The capacity of the device for storing electric charge (called its capacitance) can be changed by changing the area of the plates, by increasing or decreasing their separation, or by using different kinds of materials for the non-conducting layers.

Capacitors are often given names to suit their applications eg:

- Bypass capacitors, to short circuit AC current

- Condenser, the name used for capacitors in circuits up to the 1950's.

- Tuning capacitors, to vary the frequency of a tuned circuit

- Power Factor Correction, used to reduce reactive currents in power distrubution networks

- Whimhurst Machine, to generate high voltage by maitaing a constant charge, but moving the capacitor plates farther apart (a square law relationship)

- Radio antennas, can exhibit capacitance at certain frequencies.

Inventors

In 1745 the Leyden jar was competitively invented by Ewald Jurgen von Kleist - 4 Nov 1745. Pieter van Musschenbroek produced the first working example in Jan 1746, with the name coming from Leiden University. In 1747 William Watson discharges a Leyden jar through a circuit and comprehends electric current.

Units of Measurement

The unit of capacitance was known as the "Jar" until 1872, when the SI unit of "Farad" was assigned. (Other units were assigned at this time, volt, ampere, coulomb, ohm and farad.)   The term capacitor only became popular around the 1950's, and prior to that it was known as a condensor.

All practical realisations of the capacitor have some resistance, both leakage as well as charging and it is this combination which defines the 'loss factor'.