IEEE
You are not logged in, please sign in to edit > Log in / create account  

Milestones:Plaque mounting details

From GHN

(Difference between revisions)
Jump to: navigation, search
Line 4: Line 4:
  
 
There are also two holes along the mildline (6 inches/15.24cm) of the plaque.  They are 4 inches/10.16 cm in from the side edges (or 5 inches/12.7cm from the center) and 6 inches/15.24cm from the bottom and top edges. The plaques come with six threaded bolts ½ cm in diameter and 5 cm long.  
 
There are also two holes along the mildline (6 inches/15.24cm) of the plaque.  They are 4 inches/10.16 cm in from the side edges (or 5 inches/12.7cm from the center) and 6 inches/15.24cm from the bottom and top edges. The plaques come with six threaded bolts ½ cm in diameter and 5 cm long.  
 +
 +
 +
 +
We recommend waiting until you have the actual plaques in hand before drilling any mounting holes or preparing the masonry.
 +
 +
  
 
Below is a rough diagram of the plaque as seen from the back.   
 
Below is a rough diagram of the plaque as seen from the back.   

Revision as of 15:07, 22 December 2010

Milestone plaque mounting details

The milestone plaques come with six mounting holes in the back. There are four at the corners: 2.75 inches/6.5 cm in from the corners (as measured on the diagonal) or 1.95 inches/4.596cm in from the edges. 

There are also two holes along the mildline (6 inches/15.24cm) of the plaque.  They are 4 inches/10.16 cm in from the side edges (or 5 inches/12.7cm from the center) and 6 inches/15.24cm from the bottom and top edges. The plaques come with six threaded bolts ½ cm in diameter and 5 cm long.


We recommend waiting until you have the actual plaques in hand before drilling any mounting holes or preparing the masonry.


Below is a rough diagram of the plaque as seen from the back. 

Image:Resized_milestone_plaque_diagram.jpg